Mechanical structural design of a MEMS-based piezoresistive accelerometer for head injuries monitoring: a computational analysis by increments of the sensor mass moment of inertia.

Messina, Marco; Njuguna, James; Palas, Chrysovalantis

doi:10.3390/s18010289

Design of solar powered charging backpack. (2018)
Journal Article
TAVERNE, J., MUHAMMAD-SUKKI, F., AYUB, A.S., SELLAMI, N., ABU-BAKAR, S.H., BANI, N.A., MAS'UD, A.A. and IYI, D. 2018. Design of solar powered charging backpack. International journal of power electronics and drive systems [online], 9(2), pages 848-858. Available from: https://doi.org/10.11591/ijpeds.v9n2.pp848-858

This paper demonstrated a step by step process in designing a solar powered charging backpack that is capable of charging a mobile phone efficiently. A selection of existing products available on the market were reviewed and compared to ascertain the... Read More about Design of solar powered charging backpack..

A comparison of inductive sensors in the characterization of partial discharges and electrical noise using the chromatic technique. (2018)
Journal Article
ARDILA-REY, J.A., MONTANA, J., DE CASTRO, B.A., SCHURCH, R., ULSON, J.A.C., MUHAMMAD-SUKKI, F. and BANI, N.A. 2018. A comparison of inductive sensors in the characterization of partial discharges and electrical noise using the chromatic technique. Sensors [online], 18(4), article number 1021. Available from: https://doi.org/10.3390/s18041021

Partial discharges (PDs) are one of the most important classes of ageing processes that occur within electrical insulation. PD detection is a standardized technique to qualify the state of the insulation in electric assets such as machines and power... Read More about A comparison of inductive sensors in the characterization of partial discharges and electrical noise using the chromatic technique..

Polymeric materials for conversion of electromagnetic waves from the sun to electric power. (2018)
Journal Article
HAQUE, S.M., ARDILA-REY, J.A., UMAR, Y., RAHMAN, H., MAS'UD, A.A., MUHAMMAD-SUKKI, F. and ALBARRACIN, R. 2018. Polymeric materials for conversion of electromagnetic waves from the sun to electric power. Polymers [online], 10(3), article number 307. Available from: https://doi.org/10.3390/polym10030307

Solar photoelectric energy converted into electricity requires large surface areas with incident light and flexible materials to capture these light emissions. Currently, sunlight rays are converted to electrical energy using silicon polymeric materi... Read More about Polymeric materials for conversion of electromagnetic waves from the sun to electric power..

Model predictive cooperative localization control of multiple UAVs using potential function sensor constraints: a workflow to create sensor constraint based potential functions for the control of cooperative localization scenarios with mobile robots. (2018)
Journal Article
DENTLER, J., KANNAN, S., BEZZAOUCHA, S., OLIVARES-MENDEZ, M.A. and VOOS, H. 2019. Model predictive cooperative localization control of multiple UAVs using potential function sensor constraints: a workflow to create sensor constraint based potential functions for the control of cooperative localization scenarios with mobile robots. Autonomous robots [online], 43(1), pages 153-178. Available from: https://doi.org/10.1007/s10514-018-9711-z

The global localization of multiple mobile robots can be achieved cost efficiently by localizing one robot globally and the others in relation to it using local sensor data. However, the drawback of this cooperative localization is the requirement of... Read More about Model predictive cooperative localization control of multiple UAVs using potential function sensor constraints: a workflow to create sensor constraint based potential functions for the control of cooperative localization scenarios with mobile robots..

Annual prediction output of an RADTIRC-PV module. (2018)
Journal Article
FREIER, D., MUHAMMAD-SUKKI, F., ABU-BAKAR, S.H., RAMIREZ-INIGUEZ, R., MUNIR, A.B., YASIN, S.H.M., BANI, N.A., MAS'UD, A.A., ARDILA-REY, J.A. and KARIM, M.E. 2018. Annual prediction output of an RADTIRC-PV module. Energies [online], 11(3), article number 544. Available from: http://www.mdpi.com/1996-1073/11/3/544

The number of solar photovoltaic (PV) installations has been increasing worldwide but the high capital cost of installation continues to be the main challenge, particularly in many developing countries. The solar concentrator, a device that focuses t... Read More about Annual prediction output of an RADTIRC-PV module..

External lightning protection system for wind turbine blades - power performance. (2018)
Journal Article
AYUB, A.S., SIEW, W.H. and STICKLAND, M. 2018. External lighting protection system for wind turbine blades - power performance. CIGRE science and engineering [online], 10, pages 88-94 Available from: https://e-cigre.org/publication/CSE010-cse-010

Previous studies conducted by the authors on the aerodynamic performance of turbine blades have shown unfavourable effects of externally mounted lightning down conductors. Owing to this, one could ask whether or not externally mounted lightning down... Read More about External lightning protection system for wind turbine blades - power performance..

Effect of electron beam irradiation on structural and optical properties of Cu-doped In2O3 films prepared by RF magnetron sputtering. (2018)
Journal Article
KRISHNAN, R.R., SANJEEV, G., PRABHU, R. and PILLAI, V.P.M. 2018. Effect of electron beam irradiation on structural and optical properties of Cu-doped In2O3 films prepared by RF magnetron sputtering. JOM: journal of the Minerals, Metals and Materials Society [online], 70(5), pages 739-746. Available from: https://doi.org/10.1007/s11837-018-2776-5

Undoped and Cu-doped In2O3 films were prepared by radiofrequency magnetron sputtering technique. The effects of Cu doping and high-energy electron beam irradiation on the structural and optical properties of as-prepared films were investigated using... Read More about Effect of electron beam irradiation on structural and optical properties of Cu-doped In2O3 films prepared by RF magnetron sputtering..

Geomechanical effects of oilfield chemicals on sand failure in reservoir rocks. (2018)
Journal Article
WUYEP, E.O., OLUYEMI, G.F., YATES, K. and AKISANYA, A.R. 2018. Geomechanical effects of oilfield chemicals on sand failure in reservoir rocks. Journal of petroleum science and engineering [online], 165, pages 347-357. Available from: https://doi.org/10.1016/j.petrol.2018.02.041

Sand failure may result in the production of formation sand at the same time the formation fluids are being produced. This work examines the effects of some commonly used oilfield chemicals, specifically, biocide, corrosion inhibitor and scale inhibi... Read More about Geomechanical effects of oilfield chemicals on sand failure in reservoir rocks..

Solar energy potentials and benefits in the Gulf Cooperation Council countries: a review of substantial issues. (2018)
Journal Article
MAS'UD, A.A., WIRBA, A.V., ALSHAMMARI, S.J., MUHAMMAD-SUKKI, F., ABDULLAHI, M.M., ALBARRACIN, R. and HOQ, M.Z. 2018. Solar energy potentials and benefits in the Gulf Cooperation Council countries: a review of substantial issues. Energies [online], 11(2), article number 372. Available from: https://doi.org/10.3390/en11020372

It is a well-known fact that the fossil fuel industry has dominated the economy of the Gulf Cooperation Council (GCC) countries during the last few decades. However, recent developments show that most of the GCC countries plan to increase the share o... Read More about Solar energy potentials and benefits in the Gulf Cooperation Council countries: a review of substantial issues..

State switching of a multistable impacting system using PD-like control. (2018)
Journal Article
LIU, B., FUNG, W.-K. and LIU, Y. 2018. State switching of a multistable impacting system using PD-like control. MATEC web of conferences [online], 148: proceedings of the 2017 International conference on engineering vibration (ICoEV 2017), 4-7 September 2017, Sofia, Bulgaria, article number 10001. Available from: https://doi.org/10.1051/matecconf/201814810001

A new PD-like control law is proposed in this paper to control a multistable impacting system. This control law can switch the system from a current, undesired state to a desired one by using the differences of the displacement and velocity between t... Read More about State switching of a multistable impacting system using PD-like control..

A fast and efficient coordinated vehicle-to-grid discharging control scheme for peak shaving in power distribution system. (2018)
Journal Article
ERDOGAN, N., ERDEN, F. and KISACIKOGLU, M.A. 2018. A fast and efficient coordinated vehicle-to-grid discharging control scheme for peak shaving in power distribution system. Journal of modern power systems and clean energy [online], 6(3), pages 555-566. Available from: https://doi.org/10.1007/s40565-017-0375-z

This study focuses on the potential role of plug-in electric vehicles (PEVs) as a distributed energy storage unit to provide peak demand minimization in power distribution systems. Vehicle-to-grid (V2G) power and currently available information trans... Read More about A fast and efficient coordinated vehicle-to-grid discharging control scheme for peak shaving in power distribution system..

Mechanical structural design of a MEMS-based piezoresistive accelerometer for head injuries monitoring: a computational analysis by increments of the sensor mass moment of inertia. (2018)
Journal Article
MESSINA, M., NJUGUNA, J. and PALAS, C. 2018. Mechanical structural design of a MEMS-based piezoresistive accelerometer for head injuries monitoring: a computational analysis by increments of the sensor mass moment of inertia. Sensors [online], 18(1), article number 289. Available from: https://doi.org/10.3390/s18010289

This work focuses on the proof-mass mechanical structural design improvement of a tri-axial piezoresistive accelerometer specifically designed for head injuries monitoring where medium-G impacts are common; for example, in sports such as racing cars... Read More about Mechanical structural design of a MEMS-based piezoresistive accelerometer for head injuries monitoring: a computational analysis by increments of the sensor mass moment of inertia..

All Outputs (52)